ABB ACS880-01 Quick Installation And Start-up Manual

Also see for ACS880-01 Series: Manual User manual Firmware manual Supplement Application guide

ABB ACS880-01 Quick Installation And Start-up Manual Manual pdf 1 page image

1This guide is applicable to the global IEC and NEC North American installations .Safety instructionsWARNING! Obey these instructions. If you ignore them, injury or death, or damage to the equipment can occur. Ifyou are not a qualified electrical professional, do not do electrical installation or maintenance work.WARNING! If you activate the automatic fault reset or automatic restart functions of the drive control program,make sure that no dangerous situations can occur. These functions reset the drive automatically and continueoperation after a fault or supply break. If these functions are activated, the installation must be clearly marked asdefined in IEC/EN 61800-5-1, subclause 6.5.3, for example, “THIS MACHINE STARTS AUTOMATICALLY”.• Do not do work on the drive, motor cable, motor, or control cables when the drive is connected to the input power.Before you start the work, isolate the drive from all dangerous voltage sources and measure that there are nodangerous voltages. Always wait for 5 minutes after disconnecting the input power to let the intermediate circuitcapacitors discharge.• Do not do work on the drive when a rotating permanentmagnet motor is connected to it. A rotating permanentmagnet motor energizes the drive, including its input andoutput terminals.• Make sure that debris from drilling, cutting and grinding.does not enter the drive.• Frames R4…R9: Use the lifting eyes of the drive when youlift the drive. Do not tilt the drive. The drive is heavy andits center of gravity is high. An overturning drive cancause physical injury.1. Unpack the driveKeep the drive in its package until you are ready to install it. After unpacking, protect the drive from dust, debris andmoisture. Make sure that these items are included: cable/conduit box (frames R5…R9 of IP21 [UL Type 1]), drive, mountingtemplate, control panel, quick installation and start-up guide, multilingual residual voltage warning stickers, hardware andfirmware manuals (if ordered), options in separate packages (if ordered). Make sure that there are no signs of damage tothe items.2. Reform the capacitorsIf the drive has not been powered up for a year or more, you must reform the DC link capacitors. SeeRelated documents orcontact ABB technical support.3. Select the cables and fuses• Select the power cables. Obey the local regulations.• Input power cable: Use symmetrical shielded cable (VFD cable) for the best EMC performance. NEC installations:Conduit with continuous conductivity is also allowed and must be grounded on both ends.• Motor cable: ABB recommends symmetrically shielded VFD motor cable to reduce bearing current and wear andstress on motor insulation and to provide the best EMC performance. Although not recommended, conductorsinside continuously conductive conduit is allowed in NEC installations. Ground conduit on both ends.• Power cable types: IEC installations: Use copper cables. Aluminum cables can only be used with frame sizes R5…R9.NEC installations: Only copper conductors are allowed.• Current rating: max. load current.• Voltage rating (minimum): IEC installations: 600 V AC cable is accepted for up to 500 V AC, 750 VAC cable isaccepted for up to 600 V AC, 1000 V AC cable is accepted for up to 690 V AC. NEC installations: 600 V AC for 230 V ACDocumentation in other languages Ecodesign information (EU 2019/1781)About this document3AXD50000754618 Rev A EN2021-06-30© 2021 ABB. All rights reserved.Original instructions.—ABB INDUSTRIAL DRIVESACS880-01Quick installation and start-up guide