—Quick Start GuideARC600 Wireless Controller1 SIM card tray connector2 Antenna connector SMA (female)3 X2.1 connector for power supply Pin 1 = L (Phase), 90...264 VACPin 2 = N (Neutral)Pin 4 = PE (Protective Earth)Pin 6 = DC voltage in, 20...30 VDCPin 7 = GND4 Power switch (bottom)5 Ethernet connector and serial ports (bottom)1 2 354The device uses 230 V AC mains voltage. Carefully read through all the documentationof this product and follow the local safety regulations. The device must not be operatedif any of the panels is removed. Voltage inside the device is extremely dangerous andmay cause death or severe injury.

ABB ARC600 Quick Start Manual

Section 1 Introduction

Document conventions

Section 2 ARC600 overview

Physical interfaces

Serial panel

Antenna panel

DIN rail mounting

Section 3 Physical connections

Serial port 2

Ethernet

I/O connections

X2.3 connector

X3 connector

X4 connector

I/O LEDs

Grounding LEDs

Control functions

Disconnector actuator motor overload protection

Monitoring of the pressure of SF6 gas

Heater control

Low auxiliary voltage indication

Battery capacity test

Battery test status

Temperature measurement

Load limiter

Remote enabling and disabling of the load limiter

Reason for load limiter activity

Cyber security definition

Configuring firewall and services

Section 6 Getting started

User interface

Configuring mobile WAN

Section 7 Network configuration

Setting WAN failover and backup routing

Configuring the network monitor

Configuring DNS proxy

Section 8 Serial port configuration

Section 9 Additional system configuration

Restoring factory default settings

Section 10 Service configuration

Section 11 IEC-104 application settings

Section 12 Modbus application settings

Modbus mode

Configuring the network master to serial slaves mode

Section 13 Technical data

Section 14 Appendix Installation and mounting instructions

Installing the SIM card

Section 15 Glossary

ARC600