40AW T 2 1 0 | 2 - W I R E C O N D U C T I V I T Y, P H/O R P, P I O N T R A N S M I T T E R | O I/A W T 2 1 0 - E N R E V. C…11 ConfigurationInput/OutputUsed to configure input/output values.Menu Comment DefaultEng Low pH devices – cannot be edited if Measurement Type = Ion Concentration.Conductivity devices cannot be edited if Measurement Type = Concentration.See Easy Setup (page 28) or Sensor Setup (page 35) levels for the associated sensor type.Eng High pH devices – cannot be edited if Measurement Type = Ion Concentration.Conductivity devices cannot be edited if Measurement Type = Concentration.See Easy Setup (page 28) or Sensor Setup (page 35) levels for the associated sensor type.DampingFault Current HART only.High/LowOutput Type HART only.Linear/Function-GeneratorFunction-gen Table HART only.Enabled only if Output Type = Function-Generator.X1/Y1/X2/Y2/X3/Y3/X4/Y4/X5/Y5/Table ErrorNoneNot SavedTrim 4mA HART only.Not available if HART in multidrop or fixed output mode.Trim 20mA HART only.Not available if HART in multidrop or fixed output mode.Loop Test HART only.Not available if HART in multidrop or fixed output mode.DiagnosticsSee page 21 for all diagnostic messages/actions.Menu Comment DefaultSensor Diagnostics pH, 2-electrode conductivity, 4-electrode conductivity only.Disabled/EnabledReference Imp Limit pH only. Enabled only if Sensor Diagnostics = Enabled.Disabled/EnabledDiagnosis Status Read-only.Actual/SimulatedInput/OutputExitMenuSelectDiagnosticsExitMenuSelect