ABB C1900 Series Operating Manual

Also see for C1900 Series: Installation guide User guide Installation guide Operating instructions Operating guide

ABB C1900 Series Operating Manual Manual pdf 7 page image

58.8.8.8.8.8.8.8.8.8.8.8.AL RMT AT MANDisplaysBar Graph Display Controls – Refer to Figs.3.3(a) to (f) for functionsLED IndicatorsControl Faceplate8.8.8.8.8.8.DisplaysLED Indicators8.8.8.8.8.8.Record FaceplateControls – Refer to Figs.3.3(a) to (f) for functionsAbC or cdEFGH or hIJKLMN or nO or oPQrStUVYABCDEFGHIJKLMNOPQRSTUVY3 DISPLAYS & CONTROLSThe displays, LED indicators and operation/programmingcontrols are located on the faceplates on the front panel of theinstrument – see Fig 3.1.3.1 Displays and LED Indicators – Fig. 3.1The displays comprise 2 rows of 6 characters.At the top of each programming page (the page header) bothdisplays are used to describe the particular page selected.When parameters within the selected page are viewed, theupper display shows the parameter and the lower display showsthe value or setting for that parameter.Alarm and Channel states are indicated by separate LEDs on thefront panel faceplate(s) – see Fig. 3.1.Table 3.1 Character SetInformation.AL1 – Channel 1AL2 – Channel 2 Status of process variable alarmsAL3 – Channel 3AL4 – Channel 4CH1 – Channel 1CH2 – Channel 2 Current channel displayedCH3 – Channel 3CH4 – Channel 4Information.An 11 segment Bar Graph Display indicates deviationof the measured value from the set point.AL – States of alarms on controller channelRMT – On if the Remote set point in useAT – On if the instrument is in Automatic tuningMAN – On if the instrument is in Manual control modeFig. 3.1 Location of Displays, Controls and LED Indicators