ABB CalMaster2 Instruction Manual

Also see for CalMaster2: Quick start guide

Contents

ABB CalMaster2 Instruction Manual Manual pdf 12 page image

Field and Software ToolsCalMaster2 and CheckMaster 3 Installation10 IM/VCM2 Issue 63.2.1 Fitting an Adaptor Board to a MagMasterTo fit an adaptor:1. Turn off the power to the MagMaster and remove the covers – see Fig. 3.1.2. Remove the wiring from the terminals. Slacken the terminal screws by at least 6 turns.3. Carefully ease the sensor wiring to one side and fit the adaptor board so that the extendedpins fit into the terminals – see Fig. 3.2. Tighten the terminal screws.4. Fit and tighten the securing screw to the corner of the adaptor board.5. Connect the sensor cable leads to the adaptor plug – see Fig. 3.3. Do not fit the plug to thesocket on the adaptor board.Note. The newer series (VKH) MagMaster does not need to have this adaptor board fitted asone is already incorporated into its design.Fig. 3.2 Fitting the Adaptor BoardFig. 3.3 Fitting the Sensor Cable Plug AdaptorBoardPin 8Pin 7Pin 6Pin 5Pin 4Pin 3Pin 2Pin 1GreyPinkBlueWhitePurpleBareYellowRedDS 2SIG 2SIG 1DS 1SIG GRNDrain (optional)CD 2CD 1