General Notices Section 2 Safety Summary6 AA003700-01 rev. G. 2.0General NoticesConformity DeclarationAll ABB MB3000 Series FTIR spectrometers have the following conformitycertifications:– CB– CE– WEEE– TUV– FCC– FDA 21 CFR chap 1, sub chapter J.Refer to Appendix A, Certificates of compliance.Touching the optical parts of the detector (mirror) may damage the spectrometerand it may reduce performances.Changing the computer or instrument IP address should be done by qualifiedpersonnel only.Screws are easily inserted and tighten. If excessive force is required to set thescrews in place, remove the screw and retry, the screw is probably not properlyaligned.All components, whether in transportation, operation or storage, must be in a noncorrosive environment.Make sure to maintain a minimum of 6 inches clearance in front of heat sinks.Always install the spectrometer on a stable, hard, levelled surface.Do not use the equipment if any signs of damages are present. Contact ABBservice personnel.
