ABB PowerValue 11/31 T Operating Manual

Also see for PowerValue 11/31 T: User manual addendum User manual

ABB PowerValue 11/31 T Operating Manual Manual pdf 20 page image

Modifications reservedPage 19/494.2.2.1 Procedure1. Open the terminal block cover locatedon the rear panel of the UPS.2. Remove the protective plates of the cableentries (the bypass hole should remain closedfor safety purposes if it is not used)3. Connect the wires according to the illustrations in the subsections that follow according to yourconfiguration (11 or 31, single or dual input feed). Run the cables through the holes from thebottom to the top installing also the cable glands provided with the UPS.Note: If the UPS is used as a standalone UPS, JP1 and JP2 must be connected. If the UPSs areused in parallel configuration, the jumper between JP1 and JP2 must be removed.4. Check that all wires have been properly connected.5. Close the terminal box with the protectivecover. This is very important to preventaccess to energized cables andconnectors.6. Install the output breakers between the outputterminal and the load. The breaker should havea leakage current protective function accordingto the UPS voltage and current ratings.Protective platesCable glandCable outer diameter:18-25mmCable glandCable outer diameter:16-28mm