ABB SACE Emax 2 Installation, Operation And Maintenance Instructions For The Installer And The User
Also see for Emax E1.2: Retrofitting guideManualInstallation, operation and maintenance instructions for the installer and the user
                                                                                                             | |
Contents
| 
ABB | SACE Emax 2Electronic accessories | 6 - Other accessories69 | © 2017 ABB | 1SDH000999R0002 - ECN000058721 - Rev. BEkip Bluetooth module The Ekip Bluetooth allows connection via Bluetooth between the Ekip trip units, and a support (PC, tablet, orsmart phone) with the Ekip Connect software installed (see the previous paragraph).IMPORTANT: the Ekip Bluetooth module can also be connected to the trip units whenin service.NOTE: Ekip Bluetooth only powers the trip unit. Therefore, in order to set and to displayinformation on any electronic accessories connected to the terminal box, these must bepowered with an Ekip Supply module (see page 62).It draws its power from a rechargeable lithium-polymer battery delivered with the unit. It is connected directlyto the front test connector of the trip unit, and allows a trip unit without auxiliary voltage to be powered.It is switched on by pressing the power button on the side, and is equipped with two LEDs:• The first lit in green with the device on and the battery charge, red with the device turned on and low battery.• The second flashing blue with active Bluetooth communication.NOTE: the red flashing LED indicates that the battery is completely drained, an error condition,or malfunction of the module.The battery charging is performed by connecting the module to the USB ports of a PC with the suppliedcable. Connection to a PC automatically switches the module on, and charging in progress is indicated bythe flashing green LED, with increasing frequency as the level of charging rises. Completion of charging isindicated by the green LED on (fixed).NOTE: during recharging, the module must be kept energized.Further information on Ekip Bluetooth is available on the web site http://www.abb.com/abblibrary/DownloadCenter/, in particular in the kit sheet 1SDH001000R0518, and in the Ekip Connect software manual1SDH000891R0002.Ekip T&P module The Ekip T&P module is part of the Ekip T&P programming and test kit for Ekip trip units, and allows you to:• Supply the trip unit in the absence of auxiliary voltage.• Access the information and the pages for programming the trip unit, and activate the test pages withEkip Connect software (see page 68).IMPORTANT: Ekip T&P can also be connected to the trip units when in service. In thecase of connection to trip units in service, it is not possible to perform a trip test.NOTE: Ekip T&P only powers the trip unit. Therefore, in order to set and to display informationon any electronic accessories connected to the terminal box, these must be powered withan Ekip Supply module (see page 62).It draws its power from the PC, and connects one side directly to the test connector at the front of the tripunit, and on the other to the USB ports of the PC with the cable supplied.It turns on after connecting to the PC, and is equipped with two LEDs, a green one indicating that the moduleis on, and a yellow one indicating active communication. |
Related manuals for ABB Emax E1.2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine