Operation Manual / TPR56-F + TPR61-F7 Removal and installation / 7.1 Turbocharger weights© Copyright 2018 . All rights reserved. HZTL2490_EN Revision D May 20187 Removal and installation7.1 Turbocharger weightsLifting gear with a sufficient load limit must be used for removing andinstalling the turbocharger. The following weight specification is theheaviest variant possible. This standard value may deviate from the dataon the rating plate depending on the specification.Weight [kg] TPR56-F.. TPR61-F..360 7007.2 Removing the turbochargeru Disconnect all gas, air and oil pipes in accordance with the engineb-uilder’s instructions.CAUTIONOil orifice platesAn orifice plate for adjusting the oil pressure is fitted in each of the twooil inlet channels in the bearing casing. When the cartridge group, thebearing casing or the turbocharger is fitted to the engine, it must beensured that the orifice plates that are specified for the turbochargerhave been installed in the two oil inlet channels.u Check correct installation of oil orifice plates.Page 52 / 79
