DSLR Light-Jib Operating InstructionsDSLR Light-JibOriginal Operating Instructions 10Entering of Area ProhibitedProhibitory sign in accordance with ASR A1.3Appendix 1 (until now BGV A8, before VBG 125),DIN 4844-2 :2001-02 and DIN 4844-2/A1: 2004-05Definition: Entering of area prohibited2.2 Service AddressMovieTech AGMartin-Kollar-Str. 9D-81829 MunichE-Mail: info@movietech.dewww.movietech.deTel.: +49 (0) 89 43 68 91 33. Safety Notices3.1 General Manufacturer Safety Notices• Before first use, ensure the operating instructions have been read and understood.• Do not leave the assembled jib unattended. Protect against unauthorized use.• Limits specified by the manufacturer must be observed. Exceeding these limits must be avoidedunder all circumstances.• The jib should not be assembled under the influence of alcohol, drugs, or other narcotics.• Only qualified individuals should be assigned the responsibility of assembling, disassembling, andoperating camera cranes and jib arms. This assignment must be made in writing if necessary.• Beware of possible crushing hazards during assembly, disassembly, and operation (please seeAssembly chapter and observe the special warning for each operational phase). Warning signs on theproduct and in the operating instructions must be followed!• To avoid injuries, gloves must be worn during assembly and disassembly.• Electrical equipment, for example monitors, must always be protected from wetness and moisture.