ABH 6000 Series Installation Instructions Manual
   |
NOTES1. TRIM CAN BE MOUNTED UP, DOWN, HORIZONTALLY OR VERTICALLY.2. USES STANDARD 161 DOOR PREP.3. VISION LITE MUST BE AT LEAST 6" FROM CENTERLINE OF TRIM.87121234 PULL SIDE HANDLE ASSEMBLY14 1/4-20 NUT W/ NYLON WASHERLATCH1PUSH SIDE HANDLE ASSEMBLY11/4-20 x 2-1/2" TRUSS HD. M.S.48-32 x 3/8" FHMS6COVER281243675QTY PART DESCRIPTIONITEM#8 x 3/4" FHWS2PATENT No. 6,196,599USRC LLISTEDUc 2017 ABH Mfg., Inc.printed in USAwww.abhmfg.comE-mail: abhinfo@abhmfg.comArchitectural Builders Hardware Mfg., Inc.1222 Ardmore Ave., Itasca, IL 60143630.875.9900; FAX 800.9FAXABH (932.9224)OR6000REVISED 05-19-176000-1-14.DWGVERIFY CORRECT BACKSET AND HORIZONTALOR VERTICAL MOUNTING BEFORE DRILLING.THEN USE BACKSET TEMPLATE THAT IS SUPPLIED.HORIZONTALBACKSETWITH 7"HANDLESBACKSETHANDLESHORIZONTALWITH 5" OR 7"DOWNHANDLESUPHANDLESPUSHPULLHANDLESMIXEDPULLPUSHINSTALLATION INSTRUCTIONS:1. Prep door according to latch backset and determine if trim is to be mounted horizontal or vertical mounting using backset template.2. Install latch using either wood (item 5) or machine screws (item 2) depending on door type.3. Install trim:A) Test both handle assemblies to determine which is the push or pull type.B) Select the pull handle assembly (item 8) first.C) Place pull handle on pull side of the door and slide cam shaft into latch cam. Then place the push side handle assembly (item 4)on the push side of the door. Slide push side cam shaft into latch cam. By hand, fasten both trim handles with (4) 1/4-20machine screws (item 3) and (4) 1/4-20 hex nuts (item 7). Test both handles for free movement of the latch bolt beforetightening all screws. If latch bolt does not extend or retract freely because of any type of binding, loosen mounting screws toadjust alignment of trim handles and re-tighten screws one at a time while checking latch bolt movement from both handles.D) Test for proper operation and check that the mounting hardware (item 3) & (item 7) is tight before proceeding with the next step.E) Place covers (item 1) over push and pull trims and secure with (2) 8-32 flat head screws (item 2) on each cover .99 REF SPRINGPIN & COTTER PINREF10CAM SHAFT****PAGE 1 OF 36LATCH CAM25SQUARE-OR-ROUNDCOVER6000 SERIES INSTALLATIONALL PREP MOUNTING HOLESTO BE STRAIGHT & PARALLELTO ONE ANOTHER, THIS WILLHELP PREVENT ANY BINDINGOF MECHANICAL PARTS.10NOTE:BEFORE MOUNTING BASE ASSEMBLIESCAM PIN MUST BE ROTATED TOWARDSSIDE INDICATED BY ARROW STAMPEDON THE BASE.PUSHCAM SHAFTPULLDETAIL "A" |
Related manuals for ABH 6000 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine