ABH 6600-B-AB Series Installation Manual
   |
c 2017 ABH Mfg., Inc.printed in USAOR www.abhmfg.comE-mail: abhinfo@abhmfg.comArchitectural Builders Hardware Mfg., Inc.1222 Ardmore Ave., Itasca, IL 60143630.875.9900; FAX 800.9FAXABH (932.9224) ISSUED 02-03-176600-B-AB-1-00.DWG"B" ASYLUM TRIM ASSEMBLYFACE PLATEMORTISE LOCK8-32 x 1/4" PIN IN TORX12-24 x 3/4" PH. F.H. COM. SCW.ADAPTER PLATE889762219112B56734ITEM1AQTY1PART DESCRIPTIONPATENT No. 6,196,599 & 5,730,478"B" ASYLUM TRIM ASSEMBLY12A1A1AASYLUM COVER12C10-32 x 1/2" FHMS8-32 x 1/4 PIN TORX FLAT HD. M.S.8-32 x 3/16 PHIL. FLAT HD. M.S.288INSTALLATION INSTRUCTIONS:1. Prep for lockbody according to mortise lock manufacturer installation. Install mortise lock (item 6) using (2) 12-24 screws (item 8). Thenmount the face plate (item 7) using (2) 8-32 screws (item 9).2. A) Place the pre-assembled asylum trim assembly 1A on the side of the door that will match the diagonal mortise lock mounting throughholes.B) Place the adapter plate 2B centered with pre-assembled asylum trim assembly 1A while inserting the (2) 10-32 screws (item 5).C) After tightening the 10-32 screws (item 5) test lock and asylum trim assembly 1A for proper latch retraction and knob operation. Ifthe latch does not extend / retract or if trim knob is binding, loosen both 10-32 screws (item 5) and adjust alignment for properoperation and re-tighten.D) Place the asylum trim assembly 2A on the door so that spindle engages with the mortise lock and fasten with (4) 8-32 screws (item 4).Test the knob for latch retraction. If latch does not extend loosen both 10-32 screws (item 5) to readjust alignment and re-tighten.E) Place the asylum cover (item 2C) on the asylum trim assembly and screw together with (4) 8-32 screws (item 3).6600-B-ABPAGE 1 OF 3ASYLUM TRIM ASSEMBLYIS PRE ASSEMBLEDAT THE FACTORYNOTES1. TRIM MUST BE MOUNTED VERTICALLY.2. VISION LITE MUST BE AT LEAST 6" FROM CENTERLINE OF TRIM.3. USES AB6600 SERIES MORTISE LOCK DOOR PREP.4. MORTISE LOCK CYLINDER & LOCK CAM NOT PROVIDED.6600-B-AB SERIES, ASYLUM TRIM ROUND KNOBINSTALLATION FOR MORTISE LOCKDOWNLEVERS"B" ASYLUM HANDLESMUST BE MOUNTEDIN THIS POSITION2A2A52B2B4SPINDLE2C3EDGE GUARD NOTE:WHEN PREPPING THE DOOR,DETERMINE IF THE DOOR WILLRECEIVE AN EDGE GUARD. IF SO,THE EDGE GUARD SHOULD BEINSTALLED FIRST AND THEN THEPREP FOR THE MORTISE LOCKSHOULD BE MEASURED FROM THEOUTSIDE EDGE OF THE EDGEGUARD. |
Related manuals for ABH 600 C Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine