ABLELink MB5000 Series User Manual
                                     | |
Contents
| 
User manual Version 1.0Modbus Gateway(1) Configure Slave A: Set the IP address and TCP Port of Slave A, as well as ID range for Slave A.Enter the Slave A parameters, Salve IP 192.168.100.31, TCP Port 502, using TCP (communication protocol)as the Data Mode, and the slave device response time. Enter the ID and then click to add tothe list. Click after configuring the slave device and ID to add to the list.(2) Configure Slave B: Set the IP address and TCP Port of Slave B, as well as ID range for Slave B.Enter the Slave B parameters, Salve IP 192.168.100.32, TCP Port 502, using TCP (communication protocol)as the Data Mode, and the slave device response time. Enter the ID and then click to add tothe list. Click after configuring the slave device and ID to add to the list.Port2 “Serial Device Mode” setupPort2 is the Modbus ASCII Master device, thereforeSerial Device Mode is set to Master ,Data Mode is set to ASCIIConfigure the Slave device after the Master device is configured. Both Port2 and Port1 will need to accessdata from Slave A and Slave B, therefore repeat the procedures as for Port1.(1) Configure Slave A: Set the IP address and TCP Port of Slave A, as well as ID range for Slave A.Enter the Slave A parameters, Salve IP 192.168.100.31, TCP Port 502, using TCP (communication protocol)as the Data Mode, and the slave device response time. Enter the ID and then click to add tothe list. Click after configuring the slave device and ID to add to the list. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine