20• Deficient monitoring of the machine parts that aresubject to wear.• Improperly completed repairs or use of third-partycomponents.Product DescriptionIntended UseThe system is designed solely for pumping thefollowing media:• Lubricants with a viscosity ofNLGI 4/1‘000‘000 mPa s or less• Container size according to the datasheetLabellingThe drum pump is identified by the rating plate loca-ted on the back of the pump lifter (Figure A/no. 1). The rating plate contains information foridentifying the device.FunctionPneumatic ABNOX drum pumps are used to pumplubricants from original containers. The suction beha-vior of the standard ABNOX pumps is improved con-siderably by the adjustable follower plate pressure,since the media is forced towards the suction port.This also makes it possible to prevent the followerplate from getting stuck, for example on a seam.Designations of the componentsshown (Figure A – I)1 Pump lifter2 Pneumatic cylinder3 Pump4 One-hand remote5 Control leverRaise- Hold- Lower-6 Bleed valve7 Bottom plate8 Pump air connection9 Media outlet10 Container stop11 Follower piston plate12 Pump START- STOP-13 Pump pressure gauge/ pressure regulator14 Shut-off valve / Mains supply On- Off-15 Follower plate pressure gauge / pressureregulator16 Casters LR (option)17 Feet SF (option)18 Connection block with bleeder AB (option)19 Empty notification limit switch (option)20 Audible empty signal L (option)21 Empty signal volume control L (option)EN