STEP BY STEP BUILDVIDEO AVAILABLE ATABONG.COMManufactured By:ABONG, Incorporated5-775 Woodlawn Road WGuelph, ON N1K 1Y7You will need:SandpaperScissorsGlueMADE IN CANADAWARNING!CHOKING HAZARD - CONTAINSSMALL PARTS. NOT RECOMMENDEDFOR CHILDREN UNDER 3 YEARSRECOMMENDED FOR AGESDifficulty RaƟngRemove and set aside the Catapult Bowl (I) and theCord (L). Sand both sides of the carrier board first with150 grit and then 220 grit sandpaper.Glue the second Upright (B) to the Gantry Brace (C).Glue two Corner Braces (E) to the other Side Frame(A). Glue the second Side Frame (A) to the Upright (B)and the Cross Brace (G).Glue the End Frames (F) to the Corner Braces (E), andthe Crash Bar Halves (D) to the top of the GantryBrace (C).Glue two Corner Braces (E) and the Cross Brace (G) toa Side Frame (A). Glue the Gantry Brace (C) to anUpright (B) as shown. Glue the upright to the SideFrame (A)M I N I C ATA P U LTCMYCMMYCYCMYKK1022 Mini Catapult Instructions.ai 1 2018-08-01 5:12:32 PMK1022 Mini Catapult Instructions.ai 1 2018-08-01 5:12:32 PM