ACEC Ecoline Operating Instructions Manual
       | |
3Part 1 - INSTALLATION INSTRUCTIONS1 - GENERALThis hood is constructed ready for installation in the bottom part of an overhead unit fixed above acooker and fastened to a wall.It can be used either in the ducting version (evacuation of air to the outside) or in the filter version(internal recirculation of air).2 - SAFETY WARNINGS2.1 - When used in the extraction mode the cooker hood ducting must not be connected toa flue which is used for exhausting fumes from appliances supplied with energy otherthan electric such as a central heating flue or water heating flue.2.2 - Before connecting to the mains supply ensure that the mains voltage corresponds withthe voltage on the rating plate inside the hood.2.3 - Connect the cooker hood to the mains via a double pole switch which has 3 mmclearance between the contacts.2.4 - The appliance must be earthed.2.5 - When installed, the hood must be positioned at least 65 cm above a cookingappliance.2.6 - Never do flambé cooking under this cooker hood.2.7 - Never leave frying pans unattended during use as overheated fats and oils may catchfire.2.8 - Before carring out any kind of maintenance or cleaning, disconnect the hood fromthe mains supply.2.9 - If the room where the cooker hood is to be used contains a fuel burning appliancesuch as a central heating boiler then this must be of the room sealed or balanced fluetype. If other types of flue or appliance are fitted ensure that there is an adequatesupply of air into the room. When the cooker hood is used in conjunction with otherappliances supplied with energy other than electric, the negative pressure in the roommust not exceed 0,04 mbar to prevent fumes being drawn back into the room by thecooker hood.3 - INSTALLATIONThis device belongs to the category of semi-fitted hoods.The top part (height 13 cm) is inserted into the overhead unit.The bottom carriage, which can be extracted, remains outside the overhead unit when assembled,and must be pulled out into the working position.This hood can be installed in two different ways.3.1 - Installation using screws (without quick-connection clips)To fix the top part of the hood to the inside of the overhead unit, the base of the unit must be at adistance of 13 cm from the lower edge. |
Related manuals for ACEC Ecoline
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine