ACME ENGINEERING &MANUFACTURING CORP.P.O. Box 978Muskogee, Oklahoma 74402AcmeFan.comForm 610427This set of instructions applies to both the direct driven and belt driven fans with WSS slant housing and the WSSCslant collar. CAUTION: Model ADR36G8 should not be operated with a timer.Remove from shipping crate prior to installation. All debris and shipping material must be removed to prevent obstruction ofair flow to and from the orifice. The orifice opening on both sides must be kept clear of obstructions. Failure to keep the orificeopening clear could cause undue stresses on the propeller blades, damage to the fan, and an unsafe operating condition.INSTALLATION & MAINTENANCE INSTRUCTIONSBREEZEMASTER MODEL BDR/ADR W/WSS & WSSC3456101112151621920926113 1417 22212378182524Power Cable PathBDR COMPONENTSCODE DESCRIPTION QTY.1 Roll Pin 12 Propeller 13 5/16 Whiz Lock Nut 204 Orifice 15 Support Angle 26 5/16 X 3/4 Bolt 247 Bearing Base 28 Bearing 29 Shaft 110 Fan Sheave (with or withouthousing) 111 Motor Base 112 Rubber Ring 213 Motor 114 Motor Sheave 115 Belt 116 Belt Tightener 117 Belt Tightener Bracket 118 1/4 x 3/4 Bolt 219 1/4 Whiz Lock Nut 220 Key 8mm x 8mm 121 3/8 Lock Washer 122 3/8 x 1 1/4 bolt 123 Cable Clips 324 Large Water Plug 225 Small Water Plug 226 Water Shield 2SIZE NIN mmBDR/ADR36 45.13 1146BDR48 59.45 1510BDR48J2 62.38 1584BDR54 67.00 1702WARNING! Do not use fans in hazardous environments where the fan’s electrical system could provide ignition to combustibleor flammable materials, unless built specifically for that environment. This unit has rotating parts and safety precautionsshould be exercised during installation, operation and maintenance.Minimum Fan Center to Center Spacing Cone FansNote: This minimum distance willplace the fans in a side by sideposition with the cones touching.