ACP MSOx Quick Start & Reference Manual

Also see for MSO Series: Service manual Owner's manual

Contents

ACP MSOx Quick Start & Reference Manual Manual pdf 1 page image

To cook food using a specific entered time and power level.1. Open oven door and place food in oven. Close door.2. Press TIME ENTRY pad and enter cooking time.3. Press POWER LEVEL pad to change power level if desired.• For a lower microwave power, press pads 1 (for 10%) through 9 (for90%)• Press same number keypad again to change power level to 100%4. If stage cooking is desired, press STAGE pad and repeat steps 2 through4.5. Press START pad.6. At end of cooking cycle oven beeps and shuts off. DONE displays.This oven displays CLEAN FILTER at user definedintervals. When the message displays, ACP recommendscleaning the air filter thoroughly. Cleaning the air filterwill not shut off the message. The message will stopdisplaying automatically after 24 hours. Depending onmicrowave use and environmental conditions, the filtermay need to be cleaned more frequently.To cook food using preprogrammed cooking sequences.1. Open oven door and place food in oven. Close door.• To add an additional serving press QUANTITY pad.• Display will read, “DOUBLE.”2. Press desired pad.3. Oven begins to cook.4. At end of cooking cycle oven beeps and shuts off.DONE displays.A—For North American (UL/CSA) models, allow atleast 2” (5.1 cm) of clearance around top of oven.For International (50 Hz) models, allow at least 7”(17.8 cm) of clearance around top of oven. Properair flow around oven cools electrical components.With restricted air flow, oven may not operateproperly and life of electrical parts is reduced.B—Allow at least 2 9/16” (6.5 cm) between airdischarge on back of oven and back wall.C—Allow at least 2” (5.1 cm) around sides of oven.Refer to Product Safety Manual for Safety StatementsComplete Owner’s Manual available onlineQuick Start Reference GuideQuantityTime EntryPower LevelStageProgram SaveThis guide covers model: MSO*1234A/B0X2A/B PadUser can program up to four differentstages per keypad to combine power levelsand time changes.Changes microwave power level fordifferent stages of a cook cycle.Automatically adjusts preprogrammed cookcycle for cooking two of the same fooditem.Cooking time can be changed for eithermanual entry or programming.Programs or settings can be changed andsaved based on a user’s preference.Toggles selection between two sets ofpreprogrammed menu settings.Oven ClearancesPreprogrammed Pads1. Oven must be in READY mode. If not, open and close thedoor.2. Open the oven door completely.3. Insert USB flash drive.4. Press and hold the 5 keypad until “USB” appears on thedisplay.5. To transfer FROM the USB flash drive TO the oven, press the1 pad.• Or to transfer programs TO the USB flash drive FROM theoven, press the 2 pad.6. Push the START pad to begin transfer.• Display will read, “Contacting USB card.”• Display will then read, “Transferring data from USB to oven,”or vice versa7. Once programming has been successfully transfered, displaywill read, “Done - Loaded __ Programs.”• Shut the door to clear the display and begin a cooking cycle.USB Compatibility 2014 ACP, Inc.225 49th Avenue DriveCedar Rapids, Iowa 52404Part No.20151901Printed in U.S.A. 05/14Original InstructionsFor full product documentation visit:www.acpsolutions.comA standard USB flash drive is compatible withthe microwave oven, allowing the user to savepreprogrammed settings to the flash drive rather than theoven.CLEAN FILTERManual OperationPRELIMINARY

/ 3

Related manuals for ACP MSO Series