ACP RCS10TS Service Manual
                                | |
Contents | 
Disassembly Procedures To avoid the risk of electrical shock, personal injury, or death,disconnect power to oven and discharge the capacitors beforefollowing any disassembly procedure.32 16400009 ©2010 ACP Inc.Stirrer Motor1. Disconnect power to oven.2. Remove outer case.3. Disconnect wire terminals from stirrer motor.4. Remove screws securing stirrer motor to supportingbracket.5. Replace component and reverse procedure toreassemble.NOTE: When replacing stirrer motor, verify motor shaftis aligned with antenna shaft before securingwith screws.Magnetron Thermal Cut-Out (Mag TCO)1. Disconnect power to unit.2. Remove outer case, see "Outer Case" procedure.3. Disconnect wire terminals from TCO.4. Remove screws securing TCO to magnetron.5. Replace component and reverse procedure toreassemble.NOTE: When reconnecting wiring to thermal fuses theconnectors must be tight.Cavity Thermal Fuse1. Disconnect power to unit.2. Remove outer case, see "Outer Case" procedure.3. Disconnect wire terminals from thermal fuse.4. Remove screw securing thermal fuse to oven cavity.5. Replace component and reverse procedure toreassemble.NOTE: When reconnecting wiring to thermal fuse theconnectors must be tight.Tray Replacement1. Unplug oven from outlet.2. Using a suction cup or a thin bladed screwdriver, pryupward on front corners and remove tray from unit.3. Thoroughly clean and degrease sump area.4. Clean oven cavity bottom where new oven tray willmake contact using mineral spirits or anynonflammable degreasing solvent.NOTE: Detergents, soap, and water are not sufficient toremove oil and grease.5. Place new tray into unit.Oven Light AssemblyThe light bulb for inside of the oven can be changed onlyby removing the outer case.Follow these steps to change the bulb:1. Disconnect power to unit.2. Remove outer case, see "Outer Case" procedure.3. Remove interlock assembly, see "Interlock Assembly"procedure steps 1 through 4.4. Disconnect wire terminals from oven light socket.5. Push securing tab to release oven light asseemblyand lift upward to remove from interlock assemblybracket.6. Replace component and reverse procedure toreassemble.NOTE: After replacing the oven light assembly. Verifythe "Interlock Assembly" is properly aligned andoperating correctly.Air Guide1. Disconnect power to unit.2. Remove outer case, see "Outer Case" procedure.3. Release plastic tabs securing top portion of lightcover to inner cavity side wall.4. Lift upward on light cover to release bottom securingtabs.5. Replace component and reverse procedure toreassemble. |
Related manuals for ACP MCS10DS
manualsdatabase
Your AI-powered manual search engine