ADDC BioDigitalPC SR-60 User Manual
                            | |
Contents
| 
6When installing the SR-60 into a rack, the selected location should meet environmental standards asdescribed below.Rack Space and Airflow ConsiderationsTo allow for adequate airflow, technicians should observe the following space and airflow requirementswhen deciding where to install a rack.• Leave a minimum clearance of 36in (91.4cm) in front of the rack.• Leave a minimum clearance of 20in (50.8cm) behind the rack.Temperature ConsiderationsYour SR-60 is designed to operate at room temperature with its self-contained cooling.Power ConsiderationsWhen properly configured and installed the SR-60 can draw up to 2kW depending on the number, load,and version of the BioDigitalPC®s used. To prevent improper cooling of equipment, do not block the fans.Section 2.1 - Preparing For Your SR-60 If using the dual feed redundant power solution (See Section 2.6.2), each power source must becapable of supporting a maximum draw of 2kW.Section 2 - SR-60 Preparation |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine