15RX video displayALIF units support DVI digitalvideo signals and so use DVI-Dvideo connectors throughout.• ALIF1000 models can supporta single high resolution DVI-Dvideo display at pixel clocks upto 165MHz (equating to anexample display mode of 1920x 1200 at 60Hz refresh).• ALIF2000 models can simultaneously support up to two high resolutionvideo displays at pixel clocks up to 165MHz; or can alternatively support onevery high resolution video display (at pixel clocks up to 330MHz).To connect a digital DVI video display1 Connect the lead from the video display to the DVI-D socket on the rearpanel of the ALIF unit.DVI-DTo video displayVSCD3 cable to primaryvideo display[ALIF2000 when using one very highresolution DVI-D dual link display]Use a DVI-D Dual Link cable (suchas Adder part: VSCD3) to connectthe video display to the DVI-D-1connector of the ALIF2000 RX unit.A dual link cable must also be used atthe TX unit.When using dual link on DVI-D-1, theDVI-D-2 port will be disabled.If DVI-D-2 is already being used, thenit must be disconnected before duallink operation can occur on DVI-D-1.To primary video displayTo secondary video display[ALIF2000 when using two single linkDVI-D displays] Connect an additionalvideo input from the secondary videoport of the computer system usingthe supplied secondary DVI-D linkcable.DVI-D-2DVI-D-1USER CONSOLEDVI-D-2DVI-D-1USER CONSOLE[ALIF1000]ALIF TXLINK ALIF RXVIDEODISPLAYUSBDEVICESMIC &SPEAKERSPOWERINSERIALLINK