ADDER SmartView MultiScreen Manual 

Contents

ADDER SmartView MultiScreen Manual  Manual pdf 16 page image

 5 Mouse button switching modesYou can use a three button mouse to switch between systems. However, whenused in this way, the action of the middle mouse button or scroll wheel clickis ‘trapped’ by the Adder unit and is not passed to the system. This makes itunavailable for use in controlling applications on the selected system. The scrollwheel scrolling action is unaffected and passed on normally to the systems, onlythe scroll wheel click is used by the Adder unit.• To use the mouse buttons to change systems, use options U1 (default) orU4.• To use the scroll wheel click/third mouse button with the systems, useoptions U3 or U5.• To report only a simple 2-button mouse to the systems, use option U2.To change the mouse button switching modes1 Enter configuration mode: Press and hold the SELECT button until the SYSTEMreadout shows c.2 Press followed by a number to select the required mouse button setting,as follows:System channels are switchable using a 3-button mouse orIntelliMouse (default). Adder unit reports 2-button mouse modeto the systems.System channels are not switchable using the mouse. Adder unitreports 2-button mouse mode to the systems.System channels are not switchable using the mouse. Adder unitreports 3-button mouse mode to the systems.System channels are switchable using a 3-button mouse orIntelliMouse (default). Adder unit reports IntelliMouse mode tothe systems.System channels are not switchable using the mouse. Adder unitreports IntelliMouse mode to the systems.3 When the mouse button selection has been made, press to fix it andthen press to exit from configuration mode.All channel/active channel cyclingThe Adder unit provides the option, when cycling between the system channels,to visit each channel (irrespective of whether an active system is connected)or to only select active channels. You can affect the keyboard/mouse settingindependently from the front panel SELECT switch setting.To change keyboard/mouse channel cycling1 Enter configuration mode: Press and hold the SELECT button until the SYSTEMreadout shows c.2 Press followed by a number to select the required keyboard/mousechannel cycling setting, as follows:Cycle between all ports when switching with ‘hotkeys and Tab’or three button mouse (default).Cycle between active ports only when switching with ‘hotkeysand Tab’ or three button mouse (default).3 When the channel cycling selection has been made, press to fix it andthen press to exit from configuration mode.To change SELECT button channel cycling1 Remove power from the Adder unit. If any systems are active, either switchthem off or remove their keyboard link connectors from the Adder unit. If anoptional power supply is used, remove it.2 On the rear panel, click mini switch 6 to the required position, as follows:• To cycle between all system ports, set switch 6 to OFF.• To cycle between active ports only, set switch 6 to ON.3 Re-apply power to the Adder unit.Automatic screen saverThese configuration options allow you to blank the screen after a set periodof time has elapsed since the keyboard or mouse were last used. Power savingmonitors can sense the screen blanking action and change to sleep mode.B1 Screen blanking feature disabled (default setting).B2 Blank screen after 1 minute of inactivity.B3 Blank screen after 2 minutes of inactivity.B4 Blank screen after 4 minutes of inactivity.B5 Blank screen after 8 minutes of inactivity.B6 Blank screen after 12 minutes of inactivity.B7 Blank screen after 16 minutes of inactivity.B8 Blank screen after 20 minutes of inactivity.