ADJ ENCORE BURST 100 IP User Instructions

Contents

ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 13Encore Burst 100 IP Operating InstructionsDMX Address - DMX Address Setting.1. Press either the MENU, UP, or DOWN buttons until “DMX Address” is displayed and press ENTER.2. The current DMX address will now be displayed. Press the UP or DOWN buttons to find yourdesired DMX address and press ENTER to confirm your setting. Press the MENU button to exitwithout any changes.DMX CH Mode - This will let you select your desired DMX channel mode.1. Press either the MENU, UP, or DOWN buttons until “DMX CH Mode” is displayed and pressENTER.2. The current DMX channel mode will now be displayed. Press the UP or DOWN buttons to findyour desired DMX channel mode and press ENTER to confirm your setting. Press the MENUbutton to exit without any changes.No DMX State - This mode is used as a precaution mode. In case the DMX signal is lostor interrupted, the operating mode chosen in this setup is the running mode the fixture will revertto when the DMX signal is lost.1. Press either the MENU, UP, or DOWN buttons until “No DMX State” is displayed and press ENTER.2. Press the UP or DOWN buttons to find the operating mode you would like the unit to automaticallyrevert to if the DMX signal is lost or interrupted.- Hold Last - If the DMX signal is lost or interrupted, the unit will stay in the last DMX setting.- Blackout - If the DMX signal is lost or interrupted, the unit will automatically go into standby mode.- Manual - If the DMX signal is lost or interrupted, the unit will default to the settings made under the“Manual Control” function. See “Manual Control” on page 15 for more information.3. Once you have found your desired setting press ENTER to confirm.Dim Modes - This will let select your desired dimmer curve. In this mode the dimmerspeed can also be adjusted. The dimmer speed adjustment will affect all dimmer curve modes.1. Press either the MENU, UP, or DOWN buttons until “Dim Modes” is displayed and press ENTER.2. 1 of 6 dimmer curves or dim speed will be displayed. “Standard”, “Stage”, “TV”, “Architectural”,“Theatre”, or “Stage 2”. See the dimmer curve chart on page 18 for more info.3. Press the UP or DOWN buttons to find your desired dimmer curve and press ENTER to confirm.LED Refresh Rate - With this function you can adjust the dimming frequency.1. Press either the MENU, UP, or DOWN buttons until “LED Refresh Rate” is displayed andpress ENTER.2. Use the UP or DOWN buttons to adjust the dimming frequency between 900hz, 1000hz, 1100hz,1200hz, 1300hz, 1400hz, 1500hz, 6000hz, or 25000hz.3. Once you have found your desired setting press ENTER to confirm.