ADJ ENCORE FR50Z User Instructions

Also see for ENCORE FR150Z: User manual

Contents

ADJ Products, LLC - www.adj.com - Encore FR50z User Manual Page 13Encore FR50z Master-Slave ConfigurationMaster-Slave Configuration:This function will allows you to link units together to run in a Master-Slave set-up. In a Master-Slaveset up one unit will act as the controlling unit and the others will react to the controlling units built-inprograms. Any unit can act as a Master or as a Slave however, only one unit can be programmed toact as the “Master.”Master-Slave Connections and Settings:1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR datacables to link your units together. Remember that the Male XLR connector is the input and theFemale XLR connector is the ouput. The first unit in the chain (master) will use the female XLRconnector only. The last unit in the chain will use the male XLR connector only.2. Connect the first “Slave” unit to the “Master.”3. Set the “Master” unit to your desired mode of operation. On the “Slave” unit’s press the UP orDOWN buttons until “Function” is displayed, and press ENTER.4. Press the UP or DOWN buttons until “Disp.Set” is displayed and press ENTER. Press the UP orDOWN buttons until “Slave” is displayed and press ENTER.5. The “Slave” unit(s) will now follow the “Master”.6. To exit “Slave” mode, press the MODE button.7. To fully exit “Slave” mode, you will need to follow steps 3 and 4 and set the display to “ADDR”and press ENTER.Encore FR50z Zoom Adjustment KnobZoom Adjustment Knob:Rotate this know counter-clockwisefor a wider beam.Rotate this knob clockwise fornarrower beam.