ADJ Event Bar Q4 User Instructions

Also see for Event Bar Q4: User instructions

ADJ Products, LLC - www.adj.com - Event Bar Q4 Instruction Manual Page 13ADJ Products, LLC - www.adj.com - Event Bar Q4 Instruction Manual Page 12unit will automatically go into Master Slave mode.• Blackout - If the DMX signal is lost or power is applied, the unitwill automatically go into stand by mode.• Last State - If the DMX signal is lost the fixture will stay in thelast DMX set up. If power is applied and this mode is set, the unitwill automatically go into the last DMX set up.3. Press ENTER to confirm your desired set up.Back Light - With this function you can make the back-light automatically turn off after one minute.1. Press the MENU button until “Back Light” is displayed, pressENTER.2. Either “ON” or “OFF” will now be displayed. Press the UP orDOWN buttons to select “ON” to keep the backlight on at alltimes, or “OFF” to allow the backlight to turn off after 2 minutes.Press any button to turn the backlight on again.3. Press ENTER to confirm.Auto Test - This function will run a self test program.1. Press the MENU button until “Auto Test” is displayed, pressENTER.2. The fixture will now run a self test. Press the MENU button toexit.Pan Inverse - Pan Inversion1. Press the MENU button until “Pan Inverse” is displayed,press ENTER. Either “Normal” or “Inverse” will be displayed.2. To activate the Pan inversion press the UP or DOWN buttonsuntil “Inverse” is displayed, press ENTER to confim. To deacti-vate Pan inversion, select “Normal” and press Enter.Tilt Inverse - Tilt Inversion1. Press the MENU button until “Tilt Inverse” is displayed, pressENTER. Either “Normal” or “Inverse” will be displayed.2. To activate the Tilt inversion press the UP or DOWN buttonsuntil “Inverse” is displayed, press ENTER to confim. To deacti-vate Tilt inversion, select “Normal” and press Enter.Fixture Hours - With this function you can display therunning time of the unit.1. Press the MENU button until “Fixture Hours” is displayed,press ENTER.2. The running time of the fixture will now be displayed. PressMENU to exit.Software Version - This will display the software ver-sion1. Press the MENU button until “Software Version” is displayed.Press the ENTER button and the software vesion will be dis-played.2. Press the MENU button to leave this function.Reset - Use this function to reset the unit.1. Press the MENU button until “Reset” is displayed, pressENTER.2. The fixture will now reset.Event Bar Q4 System Menu Event Bar Q4 System Menu