ADJ Focus Spot 5Z User Instructions

ADJ Products, LLC - www.adj.com - Focus Spot 5Z User Manual Page 24Focus Spot 5Z System MenuDMX SETTINGS - The submenus listed under DMX SETTINGS are as follows: Set Address, DMXChannel Mode, and No DMX Status.- SET ADDRESS - In this submenu you can find and set your desired DMX address.- DMX CHANNEL MODE - In this submenu you can find and set your desired DMX channel mode.- NO DMX STATUS - This submenu setting is used as a precaution mode in case the DMX signalor power is lost or interrupted. The operating mode chosen in this submenu is the running modethe fixture will go into when the DMX signal is lost. Listed below are the 3 modes.• Hold Last - This setting will have the fixture stay in the last DMX setup.• Blackout - This setting will have the fixture automatically go into stand by/blackout mode.• Manual - This setting will go into the current manual control set up. See MANUAL CONTROL.PERSONALITY - The submenus listed under PERSONALITY are as follows: Master & Slave Settings,Status Settings, Fan Settings, Dim Modes, LED Refresh Rate, Dimf Curves, Reset Motors, Display,and Service.- MASTER & SLAVE SETTINGS - In this submenu you are able to designate the units as either“Master” or “Slave” unit in a master-slave set up.- STATUS SETTINGS - In this submenu you are able to access and adjust/change: Pan Degree,Pan Invert, Tilt Invert, P./T. Feedback, P./T. Speed, and Hibernation.- FAN SETTINGS - In this submenu you are able to select your desired fan speed setting.- DIM MODES - In this submenu you are able to select your desired dimmer mode and adjust thedimming speed time. See the dimmer mode chart on page 26 for more information.- LED REFRESH RATE - In this submenu you are able to select your desired LED refresh rate.- DIM CURVE - In this submenu you are able to select your desired dimmer curve. See the dimmercurve chart on page 26 for more information.- RESET MOTORS - In this submenu you are able to reset selected motors.- DISPLAY - In this submenu you you are able to adjust the display intensity, invert the display, set thedisplay lock time, and activate/deactivate the display lock.- SERVICE - In this submenu you are able to access and adjust/change: calibration (effect adjust),activate/deactivate the USB port power, update the software, and restore the factory settings.MANUAL CONTROL - This menu is for manual testing and manual control.INTERNAL PROGRAMS - In this menu you are able to select 1 of 7 internal programs to run. Programrunning speed and fade speed are adjustable.