ADJ PINPOINT GO TW User Instructions

Contents

battery recharge

PinPoint GO TW Safety PrecautionsADJ Products, LLC - www.adj.com - PinPoint GO TW User Manual Page 4• To reduce the risk of electrical shock or fire, do not expose this unitrain or moisture• Do not spill water or other liquids into or on to your unit.• Be sure that the local power outlet match that of the required volt-age for your unit.• Do not attempt to operate this unit if the power cord has beenfrayed or broken. Do not attempt to remove or break off the groundprong from the electrical cord. This prong is used to reduce the riskof electrical shock and fire in case of an internal short.• Disconnect from main power before making any type of connection.• Do not remove the cover under any conditions. There are no userserviceable parts inside.• Never operate this unit when it’s cover is removed.• Never plug this unit in to a dimmer pack• Always be sure to mount this unit in an area that will allow properventilation. Allow about 6” (15cm) between this device and a wall.• Do not attempt to operate this unit, if it becomes damaged.• This unit is intended for indoor use only, use of this product out`doors voids all warranties.• During long periods of non-use, disconnect the unit’s main power.• Always mount this unit in safe and stable matter.• Power-supply cords should be routed so that they are not likely tobe walked on or pinched by items placed upon or against them,paying particular attention to the point they exit from the unit.• Cleaning -The fixture should be cleaned only as recommended byt he manufacturer. See page 3 for cleaning details.• Heat -The appliance should be situated away from heat sourcessuch as radiators, heat registers, stoves, or other appliances (inclu-d ing amplifiers) that produce heat.• The fixture should be serviced by qualified service personnel when:A. The power-supply cord or the plug has been damaged.B. Objects have fallen, or liquid has been spilled into the appliance.C. The appliance has been exposed to rain or water.D. The appliance does not appear to operate normally or exhibits amarked change in performance.PinPoint GO TW WarrantyMANUFACTURER’S LIMITED WARRANTYA. ADJ Products, LLC hereby warrants, to the original purchaser, ADJ Products, LLC productsto be free of manufacturing defects in material and workmanship for a prescribed period fromthe date of purchase (see specific warranty period on reverse). This warranty shall be valid only if theproduct is purchased within the United States of America, including possessions andterritories. It is the owner’s responsibility to establish the date and place of purchase by acceptableevidence, at the time service is sought.B. For warranty service you must obtain a Return Authorization number (RA#) before sending back theproduct–please contact ADJ Products, LLC Service Department at 800-322-6337. Send the productonly to the ADJ Products, LLC factory. All shipping charges must be pre-paid. If the requested repairs orservice (including parts replacement) are within the terms of this warranty, ADJ Products, LLC will payreturn shipping charges only to a designated point within the United States. If the entire instrument issent, it must be shipped in it’s original package. No accessories should be shipped with the product. Ifany accessories are shipped with the product, ADJ Products, LLC shall have no liability whatsoever forloss of or damage to any such accessories, nor for the safe return thereof.C. This warranty is void if the serial number has been altered or removed; if the product is modified in anymanner which ADJ Products, LLC concludes, after inspection, affects the reliability of the product; if theproduct has been repaired or serviced by anyone other than the ADJ Products, LLC factory unless priorwritten authorization was issued to purchaser by ADJ Products, LLC; if the product is damaged becausenot properly maintained as set forth in the instruction manual.D. This is not a service contract, and this warranty does not include maintnance, cleaning or periodic checkup. During the period specified above, ADJ Products, LLC will replace defective parts at its expensewith new or refurbished parts, and will absorb all expenses for warranty service and repair labor byreason of defects in material or workmanship. The sole responsibility of ADJ Products, LLC under thiswarranty shall be limited to the repair of the product, or replacement thereof, including parts, at the solediscretion of ADJ Products, LLC. All products covered by this warranty were manufactured after August15, 2012, and bear indentifying marks to that effect.E. ADJ Products, LLC reserves the right to make changes in design and/or improvements upon its productswithout any obligation to include these changes in any products theretofore manufactured.No warranty, whether expressed or implied, is given or made with respect to any accessory supplied withproducts described above. Except to the extent prohibited by applicable law, all implied warranties madeby ADJ Products, LLC in connection with this product, including warranties of merchantability or fitness,are limited in duration to the warranty period set forth above. And no warranties, whether expressed orimplied, including warranties of merchantability or fitness, shall apply to this product after said periodhas expired. The consumer’s and/or Dealer’s sole remedy shall be such repair or replacement as isexpressly provided above; and under no circumstances shall ADJ Products, LLC be liable for any loss ordamage, direct or consequential, arising out of the use of, or inability to use, this product.This warranty is the only written warranty applicable to ADJ Products, LLC Products andsupersedes all prior warranties and written descriptions of warranty terms and conditions heretoforepublished.MANUFACTURER’S LIMITED WARRANTY PERIODS:• Lighting Products = 1-year (365 days) Limited Warranty (Such as: Special Effect Lighting, IntelligentLighting, UV lighting, Strobes, Fog Machines, Bubble Machines, Mirror Balls, Par Cans, Trussing,Lighting Stands etc. excluding LED and lamps)• Laser Products = 90-Day Limited Warranty• L.E.D. Products = 2-year (730 days) Limited Warranty (excluding motors, PCB boards, and powersupplies, which have a 1-year (365 day Limited Warranty) and batteries which have a 180 daylimited warranty).ADJ Products, LLC - www.adj.com - PinPoint GO TW User Manual Page 11

/ 8

Related manuals for ADJ PINPOINT GO TW