ADJ StarTec Series User Instructions

Contents

ADJ StarTec Series User Instructions Manual pdf 14 page image

ADJ Products, LLC - www.adj.com - Contour User Manual Page 13MANUAL TEST - Manually test the color macros.1. Press the MENU button until “MAnu” is displayed, and press ENTER.1. “CO_X” will be displayed. “X” represents the current displayed color number.3. Press ENTER to confirm. To make you LED display reappear again press any button.BACKLIGHT - Display will stay on at all times or can shut off after 10 seconds.1. Press the MENU button until “LEd” is displayed, and press ENTER.2. The display will show either “On” or “oFF”. Press the UP or DOWN buttons to select “On” to keepthe LED display on at all times, or “oFF” to switch to have the LED display switch off after 10 seconds.3. Press ENTER to confirm. To reactivate the backlight press any button.DISPLAY INVERSION - Allows you to “flip” the display 180º.1. Press the MENU button until “dISP” is displayed, and press ENTER.2. Press ENTER to “flip” the display. Press ENTER to “flip” it again.TOTAL RUNNING TIME - Display the total running time (hours) of the unit.1. Press the MENU button until “FhrS” is displayed, and press ENTER.2. The running time of the fixture will now be displayed. Press MENU to exit.SOFTWARE VERSION - Display the current software version.1. Press the MENU button until “vEr” is displayed, and press ENTER.2. The current software version will now be displayed. Press MENU to exit.DEFAULT MODE - Revert to default settings.1. Press the MENU button until “dEFA” is displayed, and press ENTER.Contour Operating InstructionsContour Master-Slave ConfigurationMaster-Slave Operation This function will allow you to link up to 16 units together and operate withouta controller. In a Master-Slave set up, one unit will act as the controlling unit and the others will reactto the controlling units programs. Any unit can act as a Master or as a Slave.1. Using approved DMX data cables, daisy chain your units together via the XLR connector on therear of the units. Remember the Male XLR connector is the input and the Female XLR connectoris the output. The first unit in the chain (master) will use the female XLR connector only - The lastunit in the chain will use the male XLR connector only. For longer cable runs we suggest a terminatorat the last fixture.2. On the master unit press the MENU button until “SLnd” is displayed, and press ENTER. Usethe UP and DOWN buttons to scroll to the “MASt” setting and press ENTER.3. After setting the master unit, find your desired operating mode.4. On the slave unit(s) press the MENU button until “SLND” is displayed, and press ENTER. Usethe UP and DOWN buttons to scroll to the “SL 1” setting and press ENTER.5. The slave unit(s) will now follow the master unit.