ADJ UBL9H User Manual

16I R B U T T O N C O L O R SBUTTON RED GREEN BLUE LIME AMBER UV0 0 0 0 255 0 01 255 0 0 0 0 02 0 255 0 0 0 03 0 0 255 0 0 04 231 68 0 0 0 05 0 117 58 0 0 06 17 0 75 0 0 447 255 83 0 0 63 08 0 109 70 0 0 09 32 0 75 0 22 3510 0 0 0 0 255 011 0 114 160 0 0 012 82 0 35 0 0 7413 255 255 0 0 255 014 0 75 136 0 0 015 81 0 35 0 0 115E D I T I N G I R B U T T O N V A L U E SThese fixtures allow the user to create custom RGBAL values and assign them to the numbered keys(0-15) on the remote control. Follow the steps below:1. In the main system menu, press MODE to navigate to “Personality,” then press SETUP. Use the UPand DOWN buttons to scroll to “IR Button Colors,” then press SETUP again.2. Use the UP and DOWN buttons to scroll to the number of the remote button that you would like touse. Options range from “Button 0” to “Button 15.” Press SETUP to select the button shown on thedisplay screen.3. Create a custom color for the button you have selected by using the UP and DOWN buttons to scrollthrough the color component options (Red, Green, Blue, Lime, Amber, UV). Press SETUP to selecta color component option, then use the UP and DOWN buttons to adjust the intensity of that colorcomponent option. Selectable values range from 000 to 255. Repeat this process until you have setthe desired Red, Green, Blue, Lime, Amber, and UV intensities to create your custom color.NOTE: Once you have created and assigned a custom color value to a remote button, the defaultcolor for the remote button will be overridden. This means that the output color of the fixturemay no longer resemble the color shown on the remote button. To return to the default colorvalues, reset the unit to the default factory settings by navigating to Personality > Service >Factory Restore.NOTE: If multiple units have been linked in a primary-secondary set up, the custom color valuesonly need to be set up on the primary unit. The custom color settings will carry over automaticallyto any secondary units in the system.I R D E F A U L T V A L U E S