ADJ penta pix User Instructions

Also see for penta pix: User instructions

ADJ Products, LLC - www.adj.com - Penta Pix Instruction Manual Page 13ADJ Products, LLC - www.adj.com - Penta Pix Instruction Manual Page 12Penta Pix DMX ControlUniversal DMX Control: This function allows you to use a univer-sal DMX-512 controller to control the colors, chases, dimmer andstrobe. A DMX controller allows you to create unique programs tai-lored to your individual needs.1. The Penta Pix has 5 DMX Modes; a 4 Channel Mode, 8 ChannelMode, 11 Channel Mode, 20 Channel Mode & 27 Channel Mode.See pages 14-20 for a detailed description of the DMX traits.2. To control your fixture in DMX mode, follow the set-up procedureson pages 5-6 as well as the set-up specifications that areincluded with your DMX controller.3. Use the controller’s faders to control the various DMX fixture traits.This will allow you to create your own programs.4. Follow the instructions on page 7 to select your desired DMXMode and to set the DMX address. After you have selected yourDMX mode and set the address, then connect your DMX control-ler.5. For longer cable runs (more than a 100 feet) use a terminator onthe last fixture.6. For help operating in DMX mode consult the manual includedwith your DMX controller.Penta Pix System Menu2. Press ENTER to change the running temperature When youpress ENTER the current temperature setting will begin to flash.Use the UP and DOWN buttons to switch between the tempera-ture settings.Temperature - In this menu you check the current run-ning temperature.1. Press the MODE button until “Temp.” is displayed.2. The current running temperature will now be displayed.White Balance - In this menu you can adjust/balancethe colors.1. Press the MODE button until “Whitebal.” is displayed.2. Press the ENTER button and the “LED” number will begin toblink. Use the UP or DOWN buttons to find the head you wouldlike to balance and press ENTER.3. Use the UP or DOWN buttons scroll through the colors. Onceyou find the color you would like to adjust press ENTER.4. Use the UP or DOWN buttons to adjust the color.Default Settings - In this menu you can reset the unitback to its default settings.1. Press the MODE button until “DFSE.” is displayed.2. Press the ENTER button and either “ON” or “OFF” will be dis-played. To reset the unit, use the UP or DOWN buttons to display“ON” and press ENTER.Master-Slave Set Up: This function will allow you to link up to 16units together and operate without a controller. In a Master-Slave setup one unit will act as the controlling unit and the others will react to thecontrolling units programs. Any unit can act as a Master or as a Slave.1. Using appropriate XLR cables, daisy chain your units together viathe XLR connector on the rear of the units. Remember the MaleXLR connector is the input and the Female XLR connector is theoutput. The first unit in the chain (master) will use the female XLRcon nector only - The last unit in the chain will use the male XLRcon nector only. For longer cable runs we suggest a terminator atthe last fixture.2. Set the Master unit to your desired operational mode.3. On the slave units press the MODE button until “SLAVE MODE”is displayed.4. The slave units will now follow the Master unit.Penta Pix Master-Slave Set Up