72 Getting Started5.4 Installing the cPCI-3510(BL) to the ChassisThe cPCI-3510(BL) may be installed in a system or peripheral slotof a 3U CompactPCI chassis. These instructions are for referenceonly. Refer to the user guide that comes with the chassis for moreinformation.1. Be sure to select the correct slot depending on the oper-ational purpose of the module. The system power maynow be powered on or off.2. Remove the blank face cover from the selected slot, ifnecessary.3. Press down on the release catches of thecPCI-3510(BL) ejector handles.4. Remove the black plastic caps securing the mountingscrews to the faceplate.5. Align the module’s top and bottom edges to the chassiscard guides, and then carefully slide the module into thechassis. A slight resistance may be felt when insertingthe module. If the resistance it too strong, check if thereare bent pins on the backplane or if the board’s connec-tor pins are not properly aligned with connectors on thebackplane. Then push the board until it is completelyflush with the chassis.6. Push the ejector handles outwards to secure the modulein place, and then fasten the screws on the module face-plate.7. Connect the cables and peripherals to the board, andthen turn the chassis on if necessary.
