ADTRAN 401 Quick Start Manual

ADTRAN 401 Quick Start Manual Manual pdf 1 page image

Quick StartD ESCRIPTIONThe 401/411 Micro Optical Network Terminal (ONT) Fiber Tray and WallMounting Bracket (ONT Fiber Tray and Bracket) is used either of thefollowing ONTs to a wall:■ ADTRAN 401 GigE Micro ONT (P/N: 11321713F1)■ ADTRAN 411 POTS + 1 GigE Micro ONT (P/N: 1287787F1)The wall mount bracket also incorporates a fiber tray to store excessincoming fiber should that be required.Required ToolsThe following tools are required when installing the ONT Fiber Tray andBracket.■ Power drill (optional)■ Carpenter’s level (optional)■ Phillips-head Screwdriver■ HammerInstallation StepsTo install the ONT Fiber Tray and Bracket, complete the following steps:1. Select Location and Mount Bracket.2. Attach Incoming Fiber Cable to ONT Fiber Tray and Bracket.3. Attach ONT to Fiber Tray.4. Connect Incoming Fiber Cable to ONT.Step 1: Select Location and Mount BracketSelect a location to mount the ONT Fiber Tray and Bracket near the fiberentrance. Use the supplied hardware to mount the bracket to the wall asfollows:g NOTESupplied hardware is intended for drywall mounting only. For mounting onsurfaces other than drywall, obtain the appropriate mounting hardwareand follow the provided instructions.1. Refer to Figure 1 and mark hole locations using the ONT Fiber Trayand Bracket as a template. Use a carpenter’s level to ensure thebracket is level.2. Start anchor into the wall by using a hammer to lightly tap theanchor in until the threads are close to the wall.g NOTEPre-drill holes using a 1/4” drill bit if difficulty is encountered.3. Insert either a No. 2 or No. 3 Phillips driver bit into the recess of theanchor head.4. Using gentle forward pressure, rotate the wall anchor clockwise untilthe collar is flush with the wall.5. Align the ONT Fiber Tray and Bracket with the anchors. Insert andtighten the #6 screws until the bracket is secured to the wall.Figure 1. ONT Fiber Tray and BracketStep 2. Attach Incoming Fiber Cable to ONT FiberTray and Bracketf CAUTION!Do not exceed a minimum bend radius of 2-inches when installingfiber cabling.Refer to Figure 2 and wrap any excess incoming fiber around theONT Fiber Tray and Bracket .Figure 2. Wrap Incoming Fiber Around ONT Fiber TrayIncomingFiberFiberConnectorFiber TrayClipsADTRAN ONT401/411Micro ONT Fiber Tray and Wall Mount BracketJanuary 201861287410F1-13AP/N: 1287410F1

/ 2

Related manuals for ADTRAN 401