Quick StartGuideOverviewThis quick start guide describes how to install Adtran’s SDG CPE Wall Mount 1 mounting kit. This kit can be used with Adtran’s 814-v6, 825-v6, 834-5, and854-6/v6 Service Delivery Gateways (SDGs).Package Contents■ Adtran’s SDG CPE Wall Mount 1 mounting bracket■ Screws and wall anchorsPrior to InstallationBefore installing the wall mount bracket, inspect it for damage. If damage has occurred during shipping, file a claim with the carrier, and then contactAdtran Customer Support.Required ToolsA #2 Phillips-head screwdriver, drill and 1/4” (6mm) drill bit are required for installing the SDG CPE Wall Mount 1 mounting bracket.Installing the Wall Mount KitDecide on a location for the gateway you want to mount on a wall, and follow these steps:1. Use the keyholes on the wall mount kit as a template and mark the wall accordingly. See Figure 1.Figure 1. Wall Mount Installation KitWARNING!f Read all warnings, cautions, notes and installation instructions before installing or servicing this equipment.CoverScrews (4x)Wall MountWall Anchors (4x)f WARNING! f CAUTION! g NOTEWARNING indicates a hazard which, ifnot avoided, could result in death, injuryor serious property damage.CAUTION indicates a hazard which, if notavoided, could result in service interruption,damage to the equipment, or minor propertydamage.NOTES inform the user of additional, butimportant, information or features.SDG CPE Wall Mount 1SDG CPE Wall Mount Kit 1June 2022617600192F1-13A P/N: 17600192F1