ADTRAN 6-Amp Power Installation And Maintenance Practice
                  | |
Total Access Rackmount 6-Amp Power Supply Battery Charger Installation and Maintenance Practice6 61180043L2-5DMounting the PS/BCThe PS/BC housing occupies a nominal area 15.35 inches (with mounting tabs) wide by 3.45inches high and is designed so the four mounting tab screw holes align to threaded screwholes on the ADTRAN battery pack housing. This procedure assumes that the battery pack ismounted in the designated 19-inch or 23-inch rack. Hardware for mounting the PS/BC to thebattery pack is included. To mount the PS/BC, perform the following steps:1. Ensure a 120 VAC wall outlet is within reach of the PS/BC 10-foot power cord.2. Determine the most convenient direction to view the status LEDs and position the PS/BCaccordingly.3. Align the mounting tabs to the threaded mounting holes on the battery pack.4. Using the included ìsemsî screws with star washer, mount the PS/BC to the battery pack.Tighten fasteners firmly.See Figure 2 for a representative example of the PS/BC mounted to the battery.Figure 2. PS/BC Mounted On Battery Pack1175044L1BATTERY BACKUPWARNING:SCREW LENGTHS EXCEEDING 3/8"MAY PUNCTURE BATTRIES.1175044L1BATTERY BACKUPWARNING:SCREW LENGTHS EXCEEDING 3/8"MAY PUNCTURE BATTRIES.1180043L2CAUTION:FOR CONTINUED PROTECTION AGAINSTRISK OF FIRE, REPLACE ONLY WITH THESAME TYPE AND RATING OF FUSE .FUSE: 12A/125VFUSEFUSE |
Related manuals for ADTRAN 6-Amp Power
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine