NetVanta 1131 RPS/EPS NetVanta 1600 Series Hardware Installation Guide42 Copyright © 2013 ADTRAN, Inc. 61700568F1-34DPowering the NetVanta 1131 and the NetVanta SwitchFollow these instructions to power your NetVanta 1131 RPS/EPS and your NetVanta switch.Your NetVanta unit is now ready to be configured and connected to the network. For information on switchconfiguration for a specific application, refer to the configuration guides provided online on ADTRAN’sSupport Forum For details on the CLI, refer to the AOS Command Reference Guide (article 2219). All otherrelated documents are also available online on ADTRAN’s Support Forum.• This unit shall be installed in accordance with Articles 300 and 400 of NEC NFPA 70.• Power to the AC system must be from an appropriately rated and grounded source.• Maximum recommended ambient operating temperature is 50o C.Instructions for Powering the NetVanta 1131 and the NetVanta SwitchStep Action1 Plug the female end of the NetVanta 1131 unit’s power cord (provided with the unit) into thepower receptacle labeled Power on the rear panel of the unit.2 Connect the other end (3-prong plug) of the unit’s power cord to the proper 110 to 130 VAC or190 to 240 VAC grounded receptacle.3 Plug the female end NetVanta switch’s power cord (provided with the unit) into the powerreceptacle on the rear panel of the unit.4 Connect the other end (3-prong plug) of the NetVanta switch’s power cord to the proper 110 to130 VAC or 190 to 240 VAC grounded receptacle.