NetVanta 6240/6250 Series HIG Unit Installation61700202G1-34B Copyright © 2013 ADTRAN, Inc. 234. UNIT INSTALLATIONThe instructions and guidelines provided in this section cover hardware installation topics, such as mountingoptions and supplying power to the unit. These instructions are presented as follows:• Tools Required on page 23• Mounting Options on page 24• Supplying DC Power to the NetVanta 6250 on page 27For information on configuring a specific application, refer to the configuration guides provided on theADTRAN’s Support Forum or the AOS Command Reference Guide.Tools RequiredThe customer-provided tools required for the hardware installation of the NetVanta are:• Ethernet cables• Network cables (module dependent)• Phillips-head screwdriver• Drill and drill bit set (wallmount applications only)To prevent electrical shock, do not install equipment in a wet location or during alightning storm.• The NetVanta 6240/6250 Series is intended to be installed, maintained, and serviced byqualified service personnel only and should be installed in a restricted access locationas described in UL/IEC 60950-1.• Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unitdirectly to Ethernet cables that run outside the building in which the unit is housed willvoid the user's warranty and could create a fire or shock hazard. To connect anADTRAN unit to Ethernet cables that run outside the building, ADTRAN's EthernetPort Protection Device (EPPD) (P/N 1700502G1) must be connected between the unitand the outside plant cable. Use of any Ethernet protector other than ADTRAN's for thispurpose will void the user's warranty.To access the CLI of the NetVanta, you will also need a PC with terminal emulationsoftware and a console port cable. Instructions on how to access the CLI are available inthe quick start guide shipped with your unit or online at ADTRAN’s Support Forum.