ADTRAN NetVanta 7000 Series Release Notes

Also see for NetVanta 7000 Series: Manual Release notes Configuration and troubleshooting guide Hardware installation guide Hardware installation guide

Contents

ADTRAN NetVanta 7000 Series Release Notes Manual pdf 10 page image

NetVanta 7000 Series Release Notes R10.8.1 Errata - System ManagementCopyright © 2013 ADTRAN, Inc. 10Errata - System ManagementThe following is a list of System Management errata that still exist in AOS version R10.8.1.• Incoming SIP trunk calls that were locally transferred would stop remote ringback during any subsequentcoverage.• A 503 Service Unavailable response was received when attempting to edit a trunk account.• The NetVanta 7100 rebooted when attempting a transfer during heavy call loads.• Hot desking configuration files only supported the use of the default VLAN 2 IP address, 10.10.20.1.• Click-to-Dial calls in a NetVanta BCS configuration were not being dialed.• TFTP client connections caused memory to be lost and not recovered.• Attempting to use a pickup group to pick up a call queue resulted in the call being dropped.• When an external call was transferred to an internal extension which was configured for coverage to anexternal number, the diversion header was missing when the call was routed back out to the externalnumber.• An inbound ring group call that was cleared too quickly resulted in a reboot.• When Music-on-Hold was set to external, Polycom IP phones were not able to blind transfer a call.• Under heavy call load it was possible that successive calls could use the same memory location to storetheir B-channel information, which caused a reboot when the latter call disconnected.• Enabling VQM caused audio to be lost when using the Simple Remote Phone feature.• The NetVanta 7100 and NetVanta 6355 platforms will fail to reset QoS map statistics for applied QoSmaps when the clear counters command is executed.• When adding a new user account, the GUI may incorrectly display an FXS port as available when it isalready assigned.• The CLI command, no description, cannot be used to remove a description from a ring groupconfiguration.• If an attempt is made to configure greater than the maximum number of call queues, an error will beshown. Following this error, no call queue configuration commands can be entered until the configurationmode is exited.• The Startup Wizard does not present an error message if an invalid VLAN ID is entered when configuringthe Data and Voice VLAN tags.• An HTTP timeout does not output the correct string in the CLI. Instead a %s is substituted.• Adding a description to a status group on the Status Groups menu of the GUI may result in a 503 ServiceUnavailable response.• After upgrading from A4.X or A5.X to R10.2 or later the GUI does not highlight Polycom IP 550/560phones to indicate the phone configuration requires updated.• When creating a new user in the GUI, DID numbers and aliases are not saved if the Edit Config button ispressed followed by the Apply button.• When using the GUI to configure voicemail notification for a user, the times midnight and noon aremistakenly swapped.• After a pickup group has been created, the pickup extension and description cannot be modified.

/ 13

Related manuals for ADTRAN NetVanta 7000 Series