ADTRAN T1 CSU ACE Manual

Also see for T1 CSU ACE: Specifications

Chapter 2. Installation28 T1 CSU ACE User Manual 61203022L1-1BWALLMOUNTING THE UNITThe T1 CSU ACE may be installed in a wallmount or tabletopconfiguration. The following section provides step-by-step instructionsfor wallmounting the unit.Instructions for WallmountingStep Action1. Decide on a location for the T1 CSU ACE. Mount the unitat or below eye-level so that the LEDs are viewable.2. Prepare the mounting surface by attaching a board(typically plywood, 3/ 4" to 1" thick) to a wall stud, using 3”wood screws.Important! Mounting to a stud ensures stability. Usingsheetrock anchors may not provide sufficient long-termstability.3. Install two #8 (1 1/ 2" or greater in length) wood screwsinto the mounted board following these guidelines andreferring to Figure 7:• Screws should be spaced horizontally, approximately5” apart. Find exact positioning by using the locationof the two eyed insets on the bottom of the unit as aguide.• Screws should be horizontally level with each other.• Leave approximately 1/4” of the screws protrudingfrom the board to allow the heads of the screws toslide into place in the unit’s keyed insets.4. Slide the keyed insets on the bottom of the T1 CSU ACEchassis securely onto the screws.5. Proceed to the steps given in Powering the Unit on page30.