jobAid1DESCRIPTIONThe NetVanta 838T SHDSL Ethernet in the First Mile (EFM) is aMetro‐Ethernet Forum (MEF) compliant, EFM bonded NTUdesigned for cost‐effective deployment of voice and data servicesto small and medium size businesses supporting up to eight two‐wire SHDSL loops. The NetVanta 838T accepts SHDSL oreSHDSL and delivers 10/100Base‐T Ethernet for customer LANextension. The NetVanta 838T terminates the SHDSL loops in RJ‐48C connectors and supports data rates from 192 kbps to 5.7Mbps per copper pair. The Total Access 838 provides an aggregatedata rate up to 45.6 Mbps over a single EFM bonding group.FEATURES♦ MEF Compliant♦ One integrated EIA‐232 configurationport (DCE)♦ Four integrated 10/100Base‐T Ethernetports♦ Eight two‐wire eSHDSL loops♦ WAN Protocol: IEEE 802.3ah EFMbonding♦ Command Line Interface (CLI)♦ Front panel LEDs♦ Wall mounting hardware included♦ Remote Management ‐ CLI using Virtual Terminal, Telnet byway of Management VLANNetVanta 838TI NSTALLATION AND TURN- UPAfter unpacking the unit, inspect it for damage. If damage isnoted, file a claim with the carrier and then contact ADTRAN. Formore information, refer to the warranty.Follow the steps listed below to wallmount or rackmount theNetVanta 838T.NOTERack Mount Install Kits must be purchased seperately forrackmount application.♦ P/N 1172984G1 ‐ NetVanta 19‐Inch Rack Mount Install Kit♦ P/N 1172985G1 ‐ NetVanta 23‐Inch Rack Mount Install Kit1. Attach mounting brackets to the side of the NetVanta 838Tin the correct orientation for either rackmount or wallmountusing the two screws provided for each bracket (refer to theillustration below for the correct orientation).WARNING!Do not upset the stability of the equipment rack after installationis complete.Mounting Bracket Orientations19 inch23 inchWall MountCLEI: VAMV200B_ _Product P/N: 1172838G1Issue Date: December 2010Document P/N: 61172838G1-22B