AEG 2000 D Installation And Operating Instructions Manual

Also see for protect d. 2000: Operating instructions

Contents

36RRRRMMLPl Remove the telescopic chimney support MMMMM by unscrewingthe side screws RRRRR (one on each side - these screws must bekept). Fig. 6Fig. 6Fig. 6Fig. 6Fig. 6.l Remove the air pipe LLLLL from the telescopic chimneysupport MMMMM; to do this, unscrew the four screws (Ø 2,9 x9,5 mm) fixing the air pipe to the support (these screwsmust be kept). Fig. 6Fig. 6Fig. 6Fig. 6Fig. 6.l Fit the telescopic chimney support to the wall, at a pointclose to the ceiling. The telescopic chimney support has areference mark PPPPP, which must coincide with the line thatyou have already drawn on the wall. Fig. 6Fig. 6Fig. 6Fig. 6Fig. 6.l Using a pencil, mark the two holes required to fix thesupport, and drill the holes (Ø 8 mm). Fig. 6Fig. 6Fig. 6Fig. 6Fig. 6.l Insert two plugs and fix the telescopic chimney support MMMMMusing 2 screws size (5x45 mm). Fig. 6Fig. 6Fig. 6Fig. 6Fig. 6.l During installation the plug must not be connected to thepower supply.Fig. 6Fig. 6Fig. 6Fig. 6Fig. 6