AEG 2600 D Operating And Installation Instructions

Also see for 2600 D: OPERATING AND INSTALLATION Manual

Contents

AEG 2600 D Operating And Installation Instructions Manual pdf 8 page image

8LED Indicator lights for verifying the saturationof filtersThis hood is supplied without a charcoal filter. If the hood is to be usedin the filter version mode with a charcoal filter, the saturation indicatormust be activated as follows:Depress and hold the A and B buttons simultaneously for 3 seconds.Initially only the LED indicator signal for the grease filter C is activated,shortly after the LED indicator for the charcoal filter D will activate, atthis point the saturation detection has been enabled.To switch off the saturation detection : depress and hold the A and Bbuttons for 3 seconds until the LED indicator for the active carbon filteris flashing.Led – Indicator for grease filter CThe LED indicator for the grease filter will flash when it requirescleaning.Follow the maintenance instructions.Led - indicator for charcoal filter DThe LED indicator for the charcoal filter illuminates when the filterrequires replacing.This occurs after about 160 working hours from when the active carbonfilter was first put into operation.Resetting the saturation indicatorAfter cleaning or replacing the filter depress and hold the G and Hbuttons again for 3 seconds until the grease filter LED or the charcoalindicator LED are no longer flashing.