AEG 61502G Operating Instructions Manual

Also see for 61502 G: Operating instructions

AEG 61502G Operating Instructions Manual Manual pdf 6 page image

6Hob burners control knobsThe symbols on the knobs mean that :z there is no gas supplythere is maximum gas supplythere is minimum gas supplyLighting the burnersFor easier lighting, proceed before putting a pan on the pan support.To light a burner:z turn the relevant knob anticlockwise to maximumposition ( ).z Upon ignition, keep the knob pushed down about 5seconds. This will allow the "thermocouple" (Fig.1 - letter D) to be heated and the safety device to beswitched off, otherwise the gas supply would beinterrupted.z Then adjust the flame as required.If the burner does not ignite, turn the control knob tozero, and try again.When switching on the mains, after installation or apower cut, it is quite normal for the spark generatorto be activated automatically.In the absence of electricity, ignition can occur withoutthe electrical device; in this case, approach theburner with a flame, push the relevant knob downand turn it anti-clockwise until it reaches the“maximum” position.To ensure maximum burner efficiency, you should only use pots and pans with a flatbottom fitting the size of the burner used (see table).OperationFig. 1A - Burner capB - Burner crownC - Ignition electrodeD - Thermocouple)