AEG 62 C4A 01 AA User Manual

• Seal the cut surfaces with a sealant toprevent moisture from causing swelling.• Protect the bottom of the appliance fromsteam and moisture.• Do not install the appliance next to a dooror under a window. This prevents hotcookware from falling from the appliancewhen the door or the window is opened.• Each appliance has cooling fans on thebottom.• If the appliance is installed above adrawer:– Do not store any small pieces orsheets of paper that could be pulledin, as they can damage the coolingfans or impair the cooling system.– Keep a distance of minimum 2 cmbetween the bottom of the applianceand parts stored in the drawer.• Remove any separator panels installed inthe cabinet below the appliance.2.2 Electrical ConnectionWARNING!Risk of fire and electric shock.• All electrical connections should be madeby a qualified electrician.• The appliance must be earthed.• Before carrying out any operation makesure that the appliance is disconnectedfrom the power supply.• Make sure that the parameters on therating plate are compatible with theelectrical ratings of the mains powersupply.• Make sure the appliance is installedcorrectly. Loose and incorrect electricitymains cable or plug (if applicable) canmake the terminal become too hot.• Use the correct electricity mains cable.• Do not let the electricity mains cabletangle.• Make sure that a shock protection isinstalled.• Use the strain relief clamp on the cable.• Make sure the mains cable or plug (ifapplicable) does not touch the hotappliance or hot cookware, when youconnect the appliance to a socket.• Do not use multi-plug adapters andextension cables.• Make sure not to cause damage to themains plug (if applicable) or to the mainscable. Contact our Authorised ServiceCentre or an electrician to change adamaged mains cable.• The shock protection of live and insulatedparts must be fastened in such a way thatit cannot be removed without tools.• Connect the mains plug to the mainssocket only at the end of the installation.Make sure that there is access to themains plug after the installation.• If the mains socket is loose, do notconnect the mains plug.• Do not pull the mains cable to disconnectthe appliance. Always pull the mains plug.• Use only correct isolation devices: lineprotecting cut-outs, fuses (screw typefuses removed from the holder), earthleakage trips and contactors.• The electrical installation must have anisolation device which lets you disconnectthe appliance from the mains at all poles.The isolation device must have a contactopening width of minimum 3 mm.2.3 UseWARNING!Risk of injury, burns and electricshock.• Remove all the packaging, labelling andprotective film (if applicable) before firstuse.• This appliance is for household (indoors)use only.• Do not change the specification of thisappliance.• Make sure that the ventilation openingsare not blocked.• Do not let the appliance stay unattendedduring operation.• Set the cooking zone to “off” after eachuse.• Do not put cutlery or saucepan lids on thecooking zones. They can become hot.• Do not operate the appliance with wethands or when it has contact with water.• Do not use the appliance as a worksurface or as a storage surface.• If the surface of the appliance is cracked,disconnect immediately the applianceENGLISH 5