AEG 79301 KF-MN Installation And Operating Instructions Manual

29Installation InstructionsSafety instructionsThe laws, ordinances, directives and standards in force in the country ofuse are to be followed (safety regulations, proper recycling in accord-ance with the regulations, etc.)Installation may only be carried out by a qualified electrician.The minimum distances to other appliances are to be observed.Drawers may only be installed with a protective board directly un-der the appliance.The cut surfaces of the work top are to be protected against moistureusing a suitable sealant.The sealant seals the appliance to the work top with no gap.Do not use silicon sealant between the appliance and the work top.Avoid installing the appliance next to doors and under windows. Other-wise hot cookware may be knocked off the rings when doors and win-dows are opened.1 WARNING!Risk of injury from electrical current.• The electrical mains terminal is live.• Observe connection schematic.• Observe electrical safety rules.• Ensure anti-shock protection through correct installation by a quali-fied electrician.• The appliance must be connected to the electrical supply by a quali-fied electrician.1 IMPORTANT!Risk of injury from electrical current.Loose and inappropriate plug and socket connections can make the ter-minal overheat.• Have the clamping joints correctedly installed by a qualified electri-cian.• Use strain relief clamp on cable.A device must be provided in the electrical installation which allows theappliance to be disconnected from the mains at all poles with a contactopening width of at least 3 mmSuitable isolation devices include line protecting cut-outs, fuses (screwtype fuses are to be removed from the holder), earth leakage trips andcontactors.