AEG BS9314001 User Manual

Also see for BS9314001: User manual User manual

• Remove the fuses from the fuse box ordeactivate the circuit breaker.CAUTION!Put a cloth on the bottom of theinterior of the appliance. It pre-vents damage to the lamp glasscover and the cavity.Always use the same lamp type.Replacing the lamp at the cavityceiling:1. Turn the lamp glass cover counter-clockwise to remove it.2. Remove the metal ring and clean theglass cover.3. Replace the lamp with a suitable 300°C heat-resistant lamp.4. Attach the metal ring to the glasscover.5. Install the glass cover.Replacing the lamp on the left side ofthe cavity:1. Remove the left shelf support.2. Use a Torx 20 screwdriver to removethe cover.3. Remove and clean the metal frameand the seal.4. Replace the lamp with a suitable 300°C heat-resistant lamp.5. Install the metal frame and the seal.Tighten the screws.6. Install the left shelf support.12.5 Cleaning the oven doorRemoving the door and the glass panelsYou can remove the oven door and theinternal glass panels to clean it. Thenumber of glass panels is different fordifferent models.WARNING!Be careful when you remove thedoor from the appliance. Thedoor is heavy.AA1. Open the door fully.2. Fully press the clamping levers (A)on the two door hinges.3. Close the oven door to the firstopening position (approximately 70°angle).4. Hold the door with one hand oneach side and pull it away from theappliance at an up angle.5. Put the door with the outer sidedown on a soft cloth on a stable sur-face. This is to prevent scratches.2B16. Hold the door trim (B) on the topedge of the door at the two sidesand push inwards to release the clipseal.7. Pull the door trim to the front to re-move it.42 www.aeg.com