AEG CHDD 8795 Operating And Installation Instructions

Also see for CHDD 8795: OPERATING AND INSTALLATION Manual OPERATING AND INSTALLATION Manual Operating and installation instructions

Contents

AEG CHDD 8795 Operating And Installation Instructions Manual pdf 7 page image

58Switching on the hood - Fig. 3The control ball is a balancer switch.Depressing the control ball repeatedly towards thebottom, switches on the hood and you may selectthe motor level desired, depressing once again thehood switches off.Switching on the light - Fig. 3Depress the control ball towards the top :once for submersed lighting,once again for full lighting,depress again to switch off the light.Indicator light for grease orcharcoal filterThe air duct, in this hood, includes a device thatsignals when the filter requires cleaning orchanging .Led signal for grease filterThe LED signal flickers (flickering green light) when the grease filterrequires cleaning, occurs at about 40 operating hours.Ensure that the indicator light is checked each time the hood is used.Led signal for charcoal filterThe LED signal flickers (flickering orange light) when the charcoal filterrequires cleaning, occurs at about 160 operating hours.Ensure that the indicator light is checked each time the hood is used.Re-setting the saturation signalAfter cleaning or replacing the filter, select the intensive speed (thecontrol ball lights up with a red flashing light), depress again and holddepressed for about 3 seconds until an audible signal indicates thereset has taken place.depress towardsthe top to switchon the lightsdepress towards thebottom to switch onthe hood.Fig. 3