AEG Electrolux FAVORIT 60760 User Manual

Also see for FAVORIT 60760: User manual

Contents

AEG Electrolux FAVORIT 60760 User Manual Manual pdf 27 page image

By removing the machine's worktop, you can install it under a close fitting sink unit or apre-existing top, providing the dimensions of the recess correspond to those shown in thepicture.Proceed as follows:1. Remove the machine's worktop by un-screwing the two rear retaining screws,pull the worktop from the back of the ma-chine and slide out the front slots, liftingthe worktop.2. Insert the machine after adjusting the lev-elling with the adjustable feet.When inserting the machine, ensure that the water inlet and drain hoses are not kinked orsquashed.During all operations that involve accessibility to internal components the dishwasher hasto be unplugged.Be sure that once the appliance has been installed, it is easily accessible for the serviceengineer in the event that a repair is required.If the dishwasher is later used as a free-standing appliance, the original worktop must bere-mounted.The plinth on free-standing appliances is not adjustable.LevellingGood levelling is essential for correct closure and sealing of the door. When the applianceis correctly levelled, the door will not catch on either side of the cabinet. If the door doesnot close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.Water connectionWater supply connectionsThis appliance can be connected to either a hot (max. 60°) or cold water supply.With a hot water supply you can have a significant reduction of energy consumption. Thishowever, depends on how the hot water is produced. (We suggest alternative sources ofenergy that are more environmentally friendly as e.g. solar or photovoltaic panels andaeolian).For making the connection itself, the coupling nut fitted to the machine's supply hose isdesigned to screw onto a 3/4" thread spout or to a purpose made quick-coupling tap suchas the Press-block.The water pressure must be within the limits given in the "Technical specifications". Yourlocal Water Authority will advise you on the average mains pressure in your area.The water inlet hose must not be kinked, crushed, or entangled when it is being connected.The dishwasher features fill and drain hoses which can be turned either to the left or theright to suit the installation by means of the locknut.The locknut must be correctly fitted to avoid water leaks.(Attention! NOT all models of dishwashers have fill and drain hoses provided with locknut.In this case, this kind of facility is not possible). If the machine is connected to new pipesWater connection 27