AEG Electrolux LAVAMAT 5.0 User Manual

40The machine must not be installed in rooms wherethe temperature can drop below 0. The water inlethose and the drain hose must not be kinked.Please ensure that when the appliance is installed, itis easily accessible for the engineer in the event of abreakdown.Carefully level by screwing the adjustable feet in orout. Never place cardboard, wood or similar materi-als under the machine to compensate for any unevenness in the floor.Automatic foot: The rear foot on the left-hand side of your washing machine isbuilt as a shock absorbing foot, which is why the appliance gives in the back left-hand corner if put under load. The automatic foot guarantees that the appliancedoes not move even at high spin speeds. Basically the automatic foot does notneed to be set.Water inletAn inlet hose is supplied and can be found inside the machine drum.Do not use the hose from your previous machine to connect to thewater supply.This appliance must be connected to a coldwater supply.1. Open the porthole and extract the inlet hose.2. Connect the hose with the angled connection tothe machine.Do not place the inlet hose downwards. Anglethe hose to the left or right depending on theposition of your water tap.3. Set the hose correctly by loosening the ring nut.After positioning the inlet hose, be sure to tightenthe ring nut again to prevent leaks.4. Connect the hose to a tap with a 3/4” thread.Always use the hose supplied with the appliance.The inlet hose must not be lengthened. If it is tooshort and you do not wish to move the tap, youwill have to purchase a new, longer hose speciallydesigned for this type of use.Installation