Select an additional rinseThis appliance is designed for saving water. However, for people with a verydelicate skin (allergic to detergents) it may be necessary to rinse the laundryusing an extra quantity of water (extra rinse).Press simultaneously the Spin Speed and Prewash buttons for some seconds:the Extra Rinse pilot light comes on in the programme progress display. Thisfunction stays permanently on. To remove it press the same buttons again untilthe Extra Rinse light goes off.When the appliance is performing additional rinses the Extra Rinse pilot lightcomes on.If the pilot light Overdosage lights up at the end of the programme, itindicates that too much detergent has been used.Altering an option or a running programmeIt is possible to change any option before the programme carries it out. Beforeyou make any change, you must pause the washing machine by pressing theStart/Pause button.Changing a running programme is possible only by resetting it. Turn theprogramme selector dial to O and then to the new programme position. Thewashing water in the tub will be not emptied out. Start the new programme bydepressing the Start/Pause button again.Interrupting a programmeDepress the Start/Pause button to interrupt a programme which is running, thecorresponding light starts to flash. Depress the button again to restart theprogramme.Cancelling a programmeTurn the selector dial to O to cancel a programme which is running. Now youcan select a new programme.Opening the door after the programme has startedFirst set the machine to pause by pressing the Start/Pause button.The door can be opened.If the door remains locked, this means that the machine is already heating, thatthe water level is above the bottom edge of the door. In this case the door cannot be opened.18 Use