Problem Possible cause RemedyThe sensor fields be-come hot.The cookware is toolarge or you put it toonear to the controls.Put large cookware onthe rear cooking zones ifnecessary.comes on. The Automatic SwitchOff operates.Deactivate the applianceand activate it again.comes on. The Child Safety Deviceor the Lock function op-erates.Refer to the chapter “Dai-ly Use”.and a number comeon.There is an error in theappliance.Disconnect the appliancefrom the electrical supplyfor some time. Discon-nect the fuse from theelectrical system of thehouse. Connect it again.If comes on again,speak to the service cen-tre.If you tried the above solutions and can-not repair the problem, speak to yourdealer or the customer service. Give thedata from the rating plate, three digitletter code for the glass ceramic (it is inthe corner of the glass surface) and anerror message that comes on.Make sure, you operated the appliancecorrectly. If not the servicing by a cus-tomer service technician or dealer willnot be free of charge, also during thewarranty period. The instructions aboutthe customer service and conditions ofguarantee are in the guarantee booklet.8. INSTALLATION INSTRUCTIONSWARNING!Refer to the Safety chapters.WARNING!Refer to "Safety information"chapter.Before the installationBefore the installation of the appliance,record the information below from therating plate. The rating plate is on thebottom of the appliance casing.• Model ...........................• PNC .............................• Serial number ....................8.1 Built-in appliances• Only use the built-in appliances afteryou assemble the appliance into cor-rect built-in units and work surfacesthat align to the standards.8.2 Connection cable• The appliance is supplied with theconnection cable.• Replace the damaged mains cablewith a special cable (type H05BB-FTmax 90°C; or higher). Speak to yourlocal Service Centre.26 www.aeg.com